Altera SDI II MegaCore Manual de usuario Pagina 62

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 89
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 61
Table 4-3: Sampling Process
The submodule executes the sampling process in the following manner.
Step Process Description
1 Detect transitions in the incoming
data.
The first part of the code detects the transitions in the
incoming data. This detection is done by comparing
adjacent bits in the incoming data word. This process
generates a word that indicates the position of the
transitions in the data
Example:
Data in = 1100000111
Transition = 0100001000
2 Generate a sample_now data by using
the transition data.
The submodule generates a sample_now bus from the
transition bus and the sample_mask. Since the data is not
sampled at the transition point, the submodule applies an
offset to which bit it selects using the sample mask. The
sample mask gives the position of the desired sample
relative to the transition point.
Example:
Data in = 1100000111
Transition = 0100001000
Sample now = 0000100001
3 Select and place the data bits in the
shift register.
If a bit in the sample_now bus is set, the corresponding bit
in the data input word is selected and placed into a shift
register. For instance, if sample_now[4] is set, the
submodule places the value of din[4] into the shift register.
Example:
Data in = 1100000111
Transition = 0100001000
Sample now = 0000100001
Data to shift reg = xxxx0xxxx1
4 Remove the data bits from the shift
register and construct a parallel
word.
The submodule removes samples from the shift register one
at a time and places them into consecutive bits in the output
word.
5 Assert dout_valid bit. The submodule asserts this bit to indicate that the word is
complete and ready for the downstream system to process.
4-20
RX Sample
UG-01125
2015.05.04
Altera Corporation
SDI II IP Core Functional Description
Send Feedback
Vista de pagina 61
1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 88 89

Comentarios a estos manuales

Sin comentarios