Altera LVDS SERDES Transmitter / Receiver Manual de usuario descargar pdf (Pagina 35)

Parameter Type Description

deserialization_factor Integer

Specifies the number of bits per channel.

The values of this parameter for each supported

device in normal mode are as follows:

• Arria II GX, Arria II GZ, Arria V, Arria V

GZ: 1 to 10.

• Arria GX: 1, 2, 4, to 10.

• Cyclone series: 1, 2, 4, to 10.

• HardCopy II, HardCopy III, and HardCopy

IV: 1, 2, 4, to 10.

• Stratix and Stratix GX: 1, 2, 4, 7, 8, to 10.

• Stratix II and Stratix II GX: 1, 2, 4, to 10.

• Stratix III, Stratix IV, and Stratix V: 1, 2, 3, 4,

to 10.

Arria GX, Arria II GX, Arria II GZ, HardCopy

II, HardCopy III, HardCopy IV, Stratix, Stratix

II, Stratix II GX, Stratix III, and Stratix IV have

the values of 1, 2, 4, to 10 with SERDES using

logic cells.

The values of this parameter for each supported

device in DPA mode are as follows:

• Arria II GX, Arria II GZ, Arria V, Arria V

GZ: 1 to 10.

• Arria GX: 1, 2, 4, to 10.

• HardCopy II, HardCopy III, and HardCopy

IV: 1, 2, 4, to 10.

• Stratix GX: 8 and 10.

• Stratix II and Stratix II GX: 1, 2, 4, to 10.

• Stratix III, Stratix IV, and Stratix V: 1 to 10.

dpa_initial_phase_value

Integer Specifies the initial phase value. The values are 0

through 7. If the parameter value is set to OFF,

the dpa_initial_phase_value parameter is set

to 0.

enable_dpa_calibration String The values are ON and OFF. The default value is

ON. Set this parameter to ON to phase shift the

PLL outputs when the dpa_pll_cal_busy

signal is high.

enable_dpa_align_to_rising_edge_

only

String Specifies that the DPA aligns to the rising edge

of data only. Values are ON and OFF. If omitted,

the default value is OFF. A value of OFF specifies

that the DPA aligns to both the rising and

falling edge of data.

UG-MF9504

2014.12.15

Command Line Interface Parameters

LVDS SERDES Transmitter/Receiver IP Cores User Guide

Altera Corporation

Send Feedback

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 71 72

Comentarios a estos manuales

Sin comentarios

Altera LVDS SERDES Transmitter / Receiver Manual de usuario Pagina 35

Comentarios a estos manuales

Relacionado con productos y manuales para Instrumentos de medición Altera LVDS SERDES Transmitter / Receiver