Altera MAX 10 Embedded Memory Manual de usuario Pagina 70

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 71
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 69
Signal Required Description
sload_data No Synchronous load data input port. Signal that specifies new multiplication
operation and cancels any existing multiplication operation. If the MAX_
CLOCK_CYCLES_PER_RESULT parameter has a value of 1, the sload_data
input port is ignored.
Table 10-2: ALTMEMMULT IP Core Output Signals
Signal Required Description
result[] Yes Multiplier output port. The size of the input port depends on the WIDTH_R
parameter value.
result_valid Yes Indicates when the output is the valid result of a complete multiplication.
If the MAX_CLOCK_CYCLES_PER_RESULT parameter has a value of 1, the
result_valid output port is not used.
load_done No Indicates when the new coefficient has finished loading. The load_done
signal asserts when a new coefficient has finished loading. Unless the
load_done signal is high, no other coefficient value can be loaded into the
memory.
ALTMEMMULT IP Core Parameters for MAX 10 Devices
Table 10-3: ALTMEMMULT IP Core Parameters for MAX 10 Devices
This table lists the IP core parameters applicable to MAX 10 devices.
Option Values Description
How wide should the 'data_
in' input bus be?
2, 3, 4, 5, 6, 7, 8, 16,
24, and 32
Specifies the width of the data_in port.
What is the representation of
'data_in'?
SIGNED,
UNSIGNED
Specifies whether the data_in input port is signed
or unsigned.
How wide should the
coefficient be?
2, 3, 4, 5, 6, 7, 8, 16,
24
Specifies the width of the coeff_in port.
What is the representation of
the coefficient?
SIGNED,
UNSIGNED
Specifies whether the coeff_in input port and the
pre-loaded coefficients are signed or unsigned.
What is the value of the
initial coefficient?
0, 1, 2, 3, and 4 Specifies value of the first fixed coefficient.
Create ports to allow loading
coefficients
On/Off Creates the coeff_in and sload_coeff port.
Create a synchronous clear
input
On/Off Creates the sclr port.
What should the RAM block
type be?
Auto, M9K Specifies the RAM block type.
10-2
ALTMEMMULT IP Core Parameters for MAX 10 Devices
UG-M10MEMORY
2015.05.04
Altera Corporation
ALTMEMMULT IP Core References
Send Feedback
Vista de pagina 69
1 2 ... 65 66 67 68 69 70 71

Comentarios a estos manuales

Sin comentarios