Altera MAX 10 Embedded Memory Manual de usuario Pagina 56

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 71
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 55
Signal Required Description
q_b Yes Data output from port B of the memory. The q_b port is required
if you set the operation_mode parameter to the following values:
DUAL_PORT
BIDIR_DUAL_PORT
The width of q_b port must be equal to the width of data_b port.
ROM:2-Port IP Core Parameters For MAX 10 Devices
Table 7-3: ROM:2-Port IP Core Parameters for MAX 10 Devices
This table lists the IP core parameters applicable to MAX 10 devices.
Option Legal Values Description
Parameter Settings: Widths/Blk Type
How do you want to specify the memory
size?
As a number of
words
As a number of bits
Determines whether to specify the
memory size in words or bits.
How many <X>-bit words of memory? Specifies the number of <X>-bit
words.
Use different data widths on different
ports
On/Off Specifies whether to use different
data widths on different ports.
Read Ports
How wide should the
‘q_a’ output bus be?
1, 2, 3, 4, 5, 6, 7, 8, 9,
16, 18, 32, 36, 64, 72,
108, 128, 144, 256, and
288
Specifies the width of the input and
output ports.
The How wide should the ‘q_b’
output bus be? option is only
available when you turn on the Use
different data widths on different
ports parameter.
How wide should
the ‘q_b’ output bus
be?
What should the memory block type be? Auto, M9K Specifies the memory block type.
The types of memory block that are
available for selection depends on
your target device.
Set the maximum block depth to Auto, 128, 256, 512,
1024, 2048, 4096, 8192
Specifies the maximum block depth
in words.
Parameter Settings: Clks/Rd, Byte En
UG-M10MEMORY
2015.05.04
ROM:2-Port IP Core Parameters For MAX 10 Devices
7-5
ROM: 2-PORT IP Core References
Altera Corporation
Send Feedback
Vista de pagina 55
1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 70 71

Comentarios a estos manuales

Sin comentarios