Altera Floating-Point Manual de usuario Pagina 83

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 157
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 82
ALTFP_INV Design Example: Understanding the Simulation Results
The simulation waveform in this design example is not shown in its entirety. Run the design example files
in the ModelSim-Altera software to see the complete simulation waveforms.
These figures show the expected simulation results in the ModelSim-Altera software.
Figure 10-1: ALTFP_INV ModelSim Simulation Waveform (Input Data)
Figure 10-2: ALTFP_INV ModelSim Simulation Waveform (Output Data)
This design example implements a floating-point inverse for single-precision format numbers. The
optional input ports (clk_en and aclr) and all four exception handling output ports (division_by_zero,
nan, zero, and underflow) are enabled.
The latency is fixed at 20 clock cycles; therefore, every inverse operation outputs results 20 clock cycles
later.
This table lists the inputs and corresponding outputs obtained from the simulation in the waveforms.
Table 10-3: Summary of Input Values and Corresponding Outputs
Time Event
0 ns, start-up data[] value: 34A2 E42Fh
Output value: An undefined value is seen on the result[] port, which is ignored.
All values seen on the output port before the 20th clock cycle are merely due to the
behavior of the system during start-up and should be disregarded.
97.5 ns Output value: 4A49 2A2Fh
Exception handling ports: division_by_zero deasserts
The inverse of a normal number results in a normal value.
UG-01058
2014.12.19
ALTFP_INV Design Example: Understanding the Simulation Results
10-3
ALTFP_INV IP Core
Altera Corporation
Send Feedback
Vista de pagina 82
1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 156 157

Comentarios a estos manuales

Sin comentarios