
Signal Name Direction Description
tx_req_pm
Input Assert this signal to request that the TX Data Link Layer send a
Power Management Data Link Layer Packet of type tx_typ_pm_
pld. Deasserts when tx_ack_pm_pld is asserted.
tx_typ_pm[2:0]
Input Lowest 3 bits of the type field for the Power Management Data
Link Layer Packet being requested by tx_req_pm_pld.
req_phypm[3:0]
Input Directs the LTSSM to low power mode.
• req_phypm[3]: L2 request
• req_phypm[2]: L1 request
• req_phypm[1]: L0s request
• req_phypm[0]: exit any low power state to L0
req_phycfg[3:0]
Input Configuration Space transition request bus:
• req_phycfg[3]: Link retrain request. Retrain the link by
writing 1b’1 in the retrain link bit in the Link Control
Register.
• req_phycfg[2]: Recovery link request. Directs the LTSSM to
the Recovery state.
• req_phycfg[1]: Hot Reset request. Directs the LTSSM to the
Hot Reset state.
• req_phycfg[0]: Disable Link request. Directs the LTSSM to
the Disable state.
vc0_tcmap_pld[7:1]
Input Each bit corresponds to a Traffic Class. Bits[7:1] correspond to
Traffic Class 7–Traffic Class 1. When a bit is set to 1, indicates
that the corresponding Traffic Class maps to VC0. Traffic Class 0
always maps to Virtual Channel 0.
inh_dllp
Input When asserted, all TLP and DLLP transmission requests are
stalled at the TX Data Link to PHY interface, except for NAK and
Power Management DLLPs.
inh_tx_tlp
Input When asserted, all TLP transmission requests are stalled at the
TX Transaction Layer to Data Link Layer interface. The Applica‐
tion Layer should assert this signal when requesting a low-power
state.
req_wake
Input When asserted, requests the LTSSM to exit from a low-power
state.
UG-01097_avst
2014.12.15
Configuration Space Bypass Mode Interface Signals
5-45
Interfaces and Signal Descriptions
Altera Corporation
Send Feedback
Comentarios a estos manuales