Altera Stratix V Avalon-ST Manual de usuario Pagina 156

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 293
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 155
Figure 8-4: MSI Interrupt Signals Timing
clk
app_msi_req
app_msi_tc[2:0]
app_msi_num[4:0]
app_msi_ack
1 2 3 5 6
4
7
valid
valid
Related Information
Correspondence between Configuration Space Registers and the PCIe Specification on page 6-1
MSI-X
You can enable MSI-X interrupts by turning on Implement MSI-X under the PCI Express/PCI Capabili‐
ties heading using the parameter editor. If you turn on the Implement MSI-X option, you should
implement the MSI-X table structures at the memory space pointed to by the BARs as part of your
Application Layer.
MSI-X TLPs are generated by the Application Layer and sent through the TX interface. They are single
dword memory writes so that Last DW Byte Enable in the TLP header must be set to 4b’0000. MSI-X
TLPs should be sent only when enabled by the MSI-X enable and the function mask bits in the message
control for MSI-X Configuration register. These bits are available on the tl_cfg_ctl output bus.
Related Information
PCI Express Base Specification 2.1 or 3.0
PCI Local Bus Specification
Implementing MSI-X Interrupts
Section 6.8.2 of the PCI Local Bus Specification describes the MSI-X capability and table structures. The
MSI-X capability structure points to the MSI-X Table structure and MSI-X Pending Bit Array (PBA)
registers. The BIOS sets up the starting address offsets and BAR associated with the pointer to the starting
address of the MSI-X table and PBA registers.
The following figure shows the Application Layer modules that implement MSI-X interrupts.
8-4
MSI-X
UG-01097_avst
2014.08.18
Altera Corporation
Interrupts
Send Feedback
Vista de pagina 155
1 2 ... 151 152 153 154 155 156 157 158 159 160 161 ... 292 293

Comentarios a estos manuales

Sin comentarios