Altera Integer Arithmetic IP Manual de usuario descargar pdf (Pagina 105)

Pre-adder

With pre-adder, additions or subtractions are done prior to feeding the multiplier.

There are five pre-adder modes:

• Simple mode

• Coefficient mode

• Input mode

• Square mode

• Constant mode

Note: When pre-adder is used (pre-adder coefficient/input/square mode), all data inputs to the multiplier

must have the same clock setting.

Pre-adder Simple Mode

In this mode, both operands derive from the input ports and pre-adder is not used or bypassed. This is the

default mode.

Figure 9-2: Pre-adder Simple Mode

Mult0

result

Pre-adder Coefficient Mode

In this mode, one multiplier operand derives from the pre-adder, and the other operand derives from the

internal coefficient storage. The coefficient storage allows up to 8 preset constants. The coefficient

selection signals are coefsel[0..3].

The following settings are applied in this mode:

• The width of the dataa[] input (WIDTH_A) must be less than or equals to 25 bits

• The width of the datab[] input (WIDTH_B) must be less than or equals to 25 bits

• The width of the coefficient input must be less than or equals to 27 bits

This mode is expressed in the following equation.

The following shows the pre-adder coefficient mode of a multiplier.

9-4

Pre-adder

UG-01063

2014.12.19

Altera Corporation

ALTMULT_ADD (Multiply-Adder)

Send Feedback

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 156 157

Sin comentarios

Altera Integer Arithmetic IP Manual de usuario Pagina 105