
Altera Corporation Reference Manual 2–3
October 2007 Arria GX Development Board
Board Components
Table 2–1 describes the components and lists their corresponding board
references.
Table 2–1. Board Components & Interfaces (Part 1 of 2)
Board
Reference
Name Description
Featured Device
U7 Arria GX FPGA EP1AGX60D FPGA in a 780-pin flip-chip FineLine BGA®
(FBGA) package.
Configuration Status and Setup Elements
S6 Board configuration
DIP switch
DIP switch that controls the FPGA and MAX II device
configuration settings.
D19 and D20 PCIe mode LEDs Yellow LEDs that display PCIe x1 or x4 mode.
D2 Configuration done LED Green LED that displays configuration status.
D12 and D13 Channel activity LEDs Yellow LEDs that indicate the RX and TX activity on HSMC
Port A.
D11 Power LED Blue LED indicates when power is applied to the board.
D21, D22, D23 Voltage present LEDs Green LEDs that indicate the presence of 1.5 V, 2.5 V, and
1.2 V power.
S5 Configuration push button Push button to reconfigure the Arria GX device.
SW2, SW3 JTAG chain bypass
switches
Switches to include or exclude HSMC Port A and MAX II from
the JTAG chain.
D1 HSMC present LED Green LED indicates when an HSMC card is connected.
J6 JTAG header 10-pin header for JTAG-based FPGA communication.
Clocks
X1 100 MHz 100-MHz oscillator
X2 125 MHz 125-MHz oscillator
X3 62.5 MHz 62.5-MHz oscillator
J4 SMA clock input SMA connector that allows the provision of an external clock.
General User Input/Output
S1, S2, S4 User push-button switches User-defined push-button switches.
D3-D10 User LEDs Eight user-defined LEDs.
S3 User DIP switch User-defined DIP switches.
Memory Devices
U8 DDR2 SDRAM 32 M x16 of DDR2 SDRAM
U6 Flash 512 Mbits of flash memory
Comentarios a estos manuales