Altera PHY IP Core Guía de usuario Pagina 211
- Pagina / 230
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Chapter 11: Migrating from Stratix IV to Stratix V Devices 11–5
XAUI PHY
March 2012 Altera Corporation Altera Transceiver PHY IP Core
User Guide
tx_coreclk
[<n> – 1:0]
xgmii_tx_clk
1
Not available —
rx_pma_ready
1
Not available —
tx_pma_ready
1
Data Ports
rx_datain
[<n>-1:0]
xaui_rx_serial
[3:0]
tx_datain
[16<n> -1:0]
xgmii_tx_dc
[63:0]
rx_dataout
[16<n> – 1:0]
xgmii_rx_dc
[63:0]
tx_dataout
[<n> -1:0]
xaui_tx_serial
[3:0]
Optional TX and RX Status Ports
gxb_powerdown
[<n>/4 – 1:0]
Not available, however you can access
them through the Avalon-MM PHY
management interface.
—
pll_locked
[<n>-1:0] Not available —
rx_locktorefclk
[<n> -1:0] Not available —
rx_locktodata
[<n> -1:0] Not available —
rx_pll_locked
[<n>/4 – 1:0] Not available —
rx_freqlocked
[<n>/4 – 1:0] Not available —
rx_phase_comp_fifo_error
[<n>/4 – 1:0] Not available —
tx_phase_comp_fifo_error
[<n>/4 – 1:0] Not available —
cal_blk_powerdown
— Not available —
rx_syncstatus
[2<n> – 1:0]
rx_syncstatus
[<n>*2 – 1:0]
rx_patterndetect
[2<n> – 1:0] Not available —
rx_invpolarity
[<n> – 1:0] Not available —
rx_ctrldetect
[2<n> – 1:0] Not available —
rx_errdetect
[2<n> – 1:0]
rx_errdetect
[<n>*2 – 1:0]
rx_disperr
[2<n> – 1:0]
rx_disperr
[<n>*2 – 1:0]
tx_invpolarity
[<n> – 1:0] Not available —
rx_runningdisp
[2<n> – 1:0] Not available —
rx_rmfifofull
[2<n> – 1:0] Not available —
rx_rmfifoempty
[2<n> – 1:0] Not available —
rx_rmfifodatainserted
[2<n> – 1:0] Not available —
rx_rmfifodatadeleted
[2<n> – 1:0] Not available —
Transceiver Reconfiguration
cal_blk_clk
1
These signals are included in the
reconfig_to_xcvr
bus.
—
reconfig_clk
1—
reconfig_togxb
[3:0]
reconfig_to_xcvr
variable
reconfig_fromgxb
[16:0]
reconfig_from_xcvr
variable
Avalon MM Management Interface
Table 11–3. Correspondences between XAUI PHY Stratix IV GX and Stratix V Device Signals (Part 2 of 3)
(1)
Stratix IV GX Devices Stratix V Devices
Signal Name Width Signal Name Width
- User Guide 1
- Contents 3
- Chapter 7. Custom PHY IP Core 5
- Contents vi 6
- 1. Introduction 9
- Stratix V Device 10
- Reset Controller 11
- Avalon-MM PHY Management 11
- 1–4 Chapter 1: Introduction 12
- Unsupported Features 13
- 1–6 Chapter 1: Introduction 14
- 2. Getting Started 15
- Note to Figure2–2: 16
- Simulate the IP Core 18
- 3. 10GBASE-R PHY IP Core 19
- Release Information 20
- Note to Table 3–1: 21
- Stratix IV Devices 23
- Stratix V Devices 24
- SDR XGMII TX Interface 30
- Note to Table 3–9: 30
- SDR XGMII RX Interface 31
- Note to Table 3–11: 31
- Status Interface 32
- Clocks, Reset, and Powerdown 32
- Serial Interface 35
- Note to Table 3–15: 35
- TimeQuest Timing Constraints 40
- Note to Figure4–1: 43
- Note to Table 4–1: 44
- Advanced Options 51
- Configurations 52
- PMA Channel Controller 58
- Stratix IV GX Devices 65
- 5. Interlaken PHY IP Core 67
- Analog Settings 70
- Note to Figure5–2: 74
- Avalon-ST TX Interface 75
- Avalon-ST RX Interface 76
- PLL Interface 78
- TX and RX Serial Interface 78
- Optional Clocks for Deskew 78
- Transceiver Reconfiguration 81
- General Options 84
- Note to Figure6–2: 90
- PIPE Interface 92
- Note to Table 6–8: 93
- Transceiver Serial Interface 94
- Registers 95
- 7. Custom PHY IP Core 101
- Device Family Support 102
- Parameter Settings 103
- Word Alignment 106
- Rate Match FIFO 107
- 8B/10B Encoder and Decoder 108
- Byte Ordering 108
- PLL Reconfiguration 109
- Analog Options 110
- Presets for Ethernet 114
- Interfaces 115
- Note to Figure7–2: 116
- Clock Interface 118
- Status Signals (Optional) 118
- Note to Table 7–17: 119
- Register Interface 120
- Register Descriptions 121
- Dynamic Reconfiguration 124
- 8. Low Latency PHY IP Core 125
- Note to Table 8–4: 129
- Note to Table 8–5: 130
- Serial Data Interface 137
- Optional Status Interface 138
- PMA and Light-Weight PCS 139
- Arria V or Stratix V FPGA 143
- Auto-Negotiation 144
- Delay Estimation Logic 145
- Note to Figure9–2: 145
- Delay Numbers 146
- Note to Table 9–4: 147
- Additional Options 150
- TX and RX Status Signals 159
- Deterministic PHY IP Core 161
- Controller 167
- Note to Figure10–1: 169
- Note to Table 10–6: 174
- Embedded 175
- Offset Cancellation 176
- Duty Cycle Calibration 176
- PMA Analog Controls 177
- Pre-CDR Reverse Serial 178
- Loopback 178
- Post-CDR Reverse Serial 178
- ATX PLL Calibration 183
- Channel Reconfiguration 187
- Streamer Module 188
- Stratix V MIF 191
- Register-Based Write 193
- Register-Based Read 193
- Direct Write Reconfiguration 195
- Figure 10–6. Sample MIF 196
- Example 10–5. (continued) 197
- Notes to Figure 10–14: 205
- Transceiver 206
- XAUI PHY 209
- Port Differences 210
- Note to Table 11–3: 212
- Note to Table 11–5: 215
- Custom PHY 216
- Note to Table 11–6: 217
- Note to Table 11–7: 218
- Additional Information 219
- Revision History 220
- Note to Table: 228
- Typographic Conventions 229
Relacionado con productos y manuales para Software Altera PHY IP Core
Software Altera UG-01080 Guía de usuario
(120 paginas)
(120 paginas)
Software Altera DE2-115 Guía de usuario
(107 paginas)
(107 paginas)
Software Altera UG-01080 Guía de usuario
(484 paginas)
(484 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.051 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales