
Chapter 2: Board Components 2–41
Power Supply
May 2014 Altera Corporation Transceiver Signal Integrity Development Kit
Stratix V GT Edition Reference Manual
Temperature Sense
The Stratix V GT die uses a MAX1619 temperature sense device for temperature
monitoring. The device connects to the MAX II CPLD EPM2210 System Controller
and the Stratix V GT device by a 2-wire SMB interface. The MAX1619 device is located
at slave address 0011000b (18h).
The
OVERTEMPn
and
TSENSE_ALERTn
signals are driven by the MAX1619 temperature
sense device based on a programmable threshold temperature. The
OVERTEMPn
signal
is driven to the MAX II System Controller. An over-temperature warning LED (D7)
indicates the temperature fault condition.
Table 2–43 lists the temperature sense interface pin assignments, signal names, and
functions.
Table 2–44 lists the temperature sense component reference and manufacturing
information.
Table 2–43. Temperature Sense Pin Assignments, Schematic Signal Names, and Functions
Board
Reference
(U12)
Schematic Signal
Name
I/O
Standard
MAX II CPLD
System Controller
Pin Number
Stratix V GT
Device
Pin Number
Description
14
SMBCLK_TEMP
3.3-V D3 B8 SMB clock
12
SMBDATA_TEMP
3.3-V C2 A8 SMB data
11
ALERTn
3.3-V D2 E8 Programmable alert
9
OVERTEMPn
3.3-V E4 E7 Fan enable
3
TEMPDIODE_P
3.3-V — V11
Current source and remote
diode input
4
TEMPDIODE_N
3.3-V — U11 Remote diode input
Table 2–44. Temperature Sense Component Reference and Manufacturing Information
Board Reference Description Manufacturer
Manufacturing
Part Number
Manufacturer
Website
U12
Temperature sense, remote and
local, programmable alert.
Maxim MAX1619MEE+T www.maxim-ic.com
Comentarios a estos manuales