Altera Transceiver Signal Integrity Development Kit, Stra Manual de usuario Pagina 40

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 52
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 39
2–32 Chapter 2: Board Components
Components and Interfaces
Transceiver Signal Integrity Development Kit May 2014 Altera Corporation
Stratix V GT Edition Reference Manual
Components and Interfaces
This section describes the development board's communication ports and interface
cards relative to the Stratix V GT device. The development board supports the
following components and interfaces:
10/100/1000 Ethernet
Transceiver interfaces
XFP interface
Small Form-Factor Pluggable (SFP+) interface
10/100/1000 Ethernet
The development board supports a 10/100/1000 BASE-T Ethernet connection using a
Marvell 88E1111 PHY device and the Altera Triple-Speed Ethernet MegaCore MAC
function. The device is an auto-negotiating Ethernet PHY with an SGMII interface to
the FPGA. The Stratix V GT device can communicate with the LVDS interfaces at up
to 1.25 Gbps. The MAC function must be provided in the FPGA for typical
networking applications. The Marvell 88E1111 PHY uses 2.5-V and 1.2-V power rails
and requires a 25-MHz reference clock driven from a dedicated oscillator. It interfaces
to an RJ-45 with internal magnetics that can be used for driving copper lines with
Ethernet traffic.
Figure 2–9 shows the SGMII interface between the FPGA (MAC) and Marvell 88E1111
PHY.
Table 231 lists the Ethernet PHY interface pin assignments.
Figure 2–9. SGMII Interface between FPGA (MAC) and Marvell 88E1111 PHY
MAC
88E1111
Device
Transformer
RJ45
SGMII Interface
S_IN
±
S_OUT ±
CAT 5 UTP:
- 10BASE-T
- 100BASE-TX
- 1000BASE-T
Table 2–31. Ethernet PHY Pin Assignments, Signal Names and Functions (Part 1 of 2)
Board
Reference (U22)
Schematic Signal Name I/O Standard
Stratix V GT
Device Pin Number
Description
23
ENET_INTN
2.5-V AL14 Management bus Interrupt
70
ENET_LED_DUPLEX
2.5-V Duplex LED
76
ENET_LED_LINK10
2.5-V 10-Mb link LED
74
ENET_LED_LINK100
2.5-V 100-Mb link LED
73
ENET_LED_LINK1000
2.5-V 1000-Mb link LED
Vista de pagina 39
1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 51 52

Comentarios a estos manuales

Sin comentarios