Altera Mentor Verification IP Altera Edition AMBA AXI4-St Manual de usuario Pagina 124

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 231
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 123
Mentor Verification IP AE AMBA AXI4-Stream User Guide, V10.3
124
VHDL Slave BFM
Slave BFM Configuration
April 2014
A slave BFM has configuration fields that you set by calling the set_config() procedure to
configure timeout factors, setup and hold times, and so on. You get the value of a configuration
field by calling the get_config() procedure. Table 9-2 describes the full list of configuration
fields.
AXI4_USER_WIDTH User data signal width in bits. This applies to the TUSER
signal. Refer to the AMBA AXI4-Stream Protocol
Specification for more details. Default: 8.
AXI4_DEST_WIDTH Destination routing signal width in bits. This applies to
the TDEST signal. Refer to the AMBA AXI4-Stream
Protocol Specification for more details. Default: 18.
AXI4_DATA_WIDTH Data signal width in bits. This applies to the TDATA
signal. Refer to the AMBA AXI4-Stream Protocol
Specification for more details. Default: 1024.
Table 9-2. Slave BFM Configuration
Configuration Field Description
Timing Variables
AXI4STREAM_CONFIG_SETUP_TIME The setup-time prior to the active
edge of ACLK, in units of
simulator time-steps for all
signals.
1
Default: 0.
AXI4STREAM_CONFIG_HOLD_TIME The hold-time after the active
edge of ACLK, in units of
simulator time-steps for all
signals.
1
Default: 0.
AXI4STREAM_CONFIG_BURST_TIMEOUT_FACTOR The maximum delay between
individual transfers in clock
cycles. Default: 10000.
AXI4STREAM_CONFIG_MAX_LATENCY_TVALID_
ASSERTION_TO_TREADY
The maximum delay permitted
between the assertion of
TVALID to the assertion of
TREADY. Default: 10000.
Master Attributes
AXI4STREAM_LAST_DURING_IDLE Controls the value of TLAST
during idle.
0 = TLAST driven to 0 during
idle (default)
1 = TLAST driven to 1 during
idle
Table 9-1. Slave BFM Signal Width Parameters (cont.)
Signal Width Parameter Description
Vista de pagina 123
1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 230 231

Comentarios a estos manuales

Sin comentarios