Altera Low Latency Ethernet 10G MAC Manual de usuario Pagina 84

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 109
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 83
Signal Operating
Mode
Direction Width Description
tx_156_25_clk 10G, 1G/10G,
10M/100M/
1G/10G
In 1
156.25-MHz clock for the MAC TX
datapath when you choose to
maintain compatibility with the 64-
bit Ethernet 10G MAC on the
Avalon-ST TX data interface or
XGMII. This feature is not available
when the Enable 10GBASE-R
register mode is enabled.
Altera recommends that this clock
and tx_312_5_clk share the same
clock source. This clock must be
synchronous to tx_312_5_clk.
Their rising edges must align and
must have 0 ppm and phase-shift.
tx_rst_n All In 1 Active-low reset for the MAC TX
datapath.
rx_312_5_clk 10G, 1G/10G,
10M/100M/
1G/10G
In 1 312.5-MHz clock for the MAC RX
datapath when the Enable
10GBASE-R register mode is
disabled. You may use the same
clock source for this clock and tx_
312_5_clk.
rx_xcvr_clk 10G In 1 322.265625-MHz clock for the MAC
RX datapath when the Enable
10GBASE-R register mode is
enabled.
rx_156_25_clk 10G, 1G/10G,
10M/100M/
1G/10G
In 1
156.25-MHz clock for the MAC RX
datapath when you choose to
maintain compatibility with the 64-
bit Ethernet 10G MAC on the
Avalon-ST RX data interface or
XGMII. This feature is not available
when the Enable 10GBASE-R
register mode is enabled.
Altera recommends that you use the
same clock source for this clock and
rx_312_5_clk. This clock must be
synchronous to rx_312_5_clk.
Their rising edges must align and
must have 0 ppm and phase-shift.
5-2
Clock and Reset Signals
UG-01144
2014.12.15
Altera Corporation
Interface Signals for LL Ethernet 10G MAC
Send Feedback
Vista de pagina 83
1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 108 109

Comentarios a estos manuales

Sin comentarios