Altera Cyclone V SoC Development Board Manual de usuario Pagina 25

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 68
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 24
Chapter 2: Board Components 2–17
Setup Elements
November 2013 Altera Corporation Cyclone V SoC Development Board
Reference Manual
Setup Elements
The development board includes several different kinds of setup elements. This
section describes the following setup elements:
Board settings DIP switch
JTAG chain control DIP switch
FPGA configuration mode DIP switch
HPS jumpers
CPU reset push button
MAX V reset push button
Program configuration push button
Program select push button
f For more information about the default settings of the DIP switches, refer to the
Cyclone V SoC Development Kit User Guide.
Board Settings DIP Switch
The board settings DIP switch (SW2) controls various features specific to the board
and the MAX V CPLD 5M2210 System Controller logic design. Table 28 lists the
switch controls and descriptions.
Table 2–8. Board Settings DIP Switch Controls
Switch Schematic Signal Name Description
1
CLK125A_EN
ON: Select programmable oscillator clock
OFF: Select SMA input clock
2
Si570_EN
ON: Disable on-board oscillator
OFF: Enable on-board oscillator
3
FACTORY_LOAD
ON: Load the factory design from flash at power up.
OFF: Disable the PFL and do not configure from flash.
4
SECURITY_MODE
ON: Embedded USB-Blaster II sends FACTORY command at
power up.
OFF: Embedded USB-Blaster II will not send FACTORY
command at power up.
Vista de pagina 24
1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 67 68

Comentarios a estos manuales

Sin comentarios