
DescriptionLegal
Values
Default
Value
Parameter
When On, read is asserted high.On/OffOnAssert read high
When On, write is asserted high.On/OffOnAssert write high
When On, byteenable is asserted high.On/OffOnAssert byteenable high
When On, readdatavalid is asserted high.On/OffOnAssert readdatavalid high
When On, arbiterlock is asserted high.On/OffOnAssert arbiterlock high
When On, lock is asserted high.On/OffOnAssert lock high
Burst Attributes
When On, the address for bursts wraps instead of
an incrementing. With a wrapping burst, when the
address reaches a burst boundary, it wraps back to
the previous burst boundary. Consequently, only the
low order bits need to be used for addressing.
On/OffOnLinewrap burst
When On, memory bursts are aligned to the address
size.
On/OffOnBurst on burst boundaries
only
Miscellaneous
The maximum number of pending reads which can
be queued up by the slave.
N/A1Maximum pending reads
For VHDL BFMs only. Use this option to assign a
unique number to each BFM in the testbench design.
0–10230VHDL BFM ID
Timing
Sets the read latency for fixed-latency slaves. Not
used on interfaces that include the readdatavalid
signal.
N/A0Fixed read latency (cycles)
For slave interfaces that do not use the waitrequest
signal. The read wait time indicates the number of
cycles before the slave responds to a read. The timing
is as if the slave asserted waitrequest for this
number of cycles.
N/A1Fixed read wait time (cycles)
For slave interfaces that do not use the waitrequest
signal. The write wait time indicates the number of
cycles before the slave accepts a write.
N/A0Fixed write wait time (cycles)
Specifies whether to turn on the register stage.On/OffOnRegistered waitrequest
Specifies whether to register incoming signals.On/OffOnRegistered Incoming Signals
Interface Address Type
Sets slave interface address type to symbols or words.WORDS/
SYMBOLS
WORDSSet slave interface address
type to symbols or words
Altera Corporation
Avalon-MM Slave BFM
Send Feedback
6-9
Parameters
Comentarios a estos manuales