
6–14 Chapter 6: Board Test System
Using the Board Test System
Transceiver Signal Integrity Development Kit, February 2013 Altera Corporation
Stratix V GT Edition User Guide
The Amphenol Tab
The Amphenol tab allows you to run a x4 backplane loopback test through the
Amphenol connector. Figure 6–7 shows the Amphenol tab.
1 No external loopback is provided. A loopback backplane can be purchased from
Amphenol.
The following sections describe the controls on the Amphenol tab.
Status
■ The Status control displays status information during the loopback test. For
details on this control, refer to “Status” on page 6–11.
Port
The Port control allows you to specify the type of test to run on the Amphenol port.
The following Amphenol port test is available:
■ Amphenol x4 Transceivers
Figure 6–7. The Amphenol Tab
Comentarios a estos manuales