Altera Stratix IV GX FPGA Manual de usuario descargar pdf (Pagina 15)

Chapter 3: Software Installation 3–3

Installing the USB-Blaster Driver

March 2014 Altera Corporation Stratix IV GX FPGA Development Kit User Guide

The installation program creates the Stratix IV GX FPGA Development Kit directory

structure shown in Figure 3–2.

Table 3–1 lists the file directory names and a description of their contents.

Installing the USB-Blaster Driver

The Stratix IV GX FPGA development board includes integrated USB-Blaster circuitry

for FPGA programming. However, for the host computer and board to communicate,

you must install the USB-Blaster driver on the host computer.

f Installation instructions for the USB-Blaster driver for your operating system are

available on the Altera website. On the Altera Programming Cable Driver Information

page of the Altera website, locate the table entry for your configuration and click the

link to access the instructions.

Figure 3–2. Stratix IV GX FPGA Development Kit Installed Directory Structure (1)

Note to Figure 3–2:

(1) Early-release versions might have slightly different directory names.

documents

board_design_files

The default Windows installation directory is C:\altera\

examples

factory_recovery

demos

kits

stratixIVGX_4sgx230_fpga

Table 3–1. Installed Directory Contents

Directory Name Description of Contents

board_design_files

Contains schematic, layout, assembly, and bill of material board design files. Use these files as a

starting point for a new prototype board design.

demos Contains demonstration applications.

documents Contains the kit documentation.

examples Contains the sample design files for the Stratix IV GX FPGA Development Kit.

factory_recovery

Contains the original data programmed onto the board before shipment. Use this data to restore

the board with its original factory contents.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 57 58

Sin comentarios

Altera Stratix IV GX FPGA Manual de usuario Pagina 15