Altera Nios II Embedded Evaluation Kit Cyclone III Editio Manual de usuario Pagina 22

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 80
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 21
Altera Corporation Development Board Version 1.0. 2–2
July 2010 Nios II Embedded Evaluation Kit, Cyclone III Edition
Development Board Setup
Requirements
If not already installed, you should:
Install the Quartus II Web Edition software on the host computer. For
more information, refer to “Installing the Quartus II Web Edition
Software” on page 1–9.
Install the Nios II Embedded Evaluation Kit, Cyclone III Edition. For
more information, refer to “Installing the Nios II Embedded
Evaluation Kit, Cyclone III Edition” on page 1–7.
Install the USB-Blaster
driver software on the host computer. The
Cyclone III FPGA starter development board includes integrated
USB-Blaster circuitry for FPGA programming.
1 The USB Blaster driver software is provided with the Quartus II
software installation
. Communication between the host
computer and the development board requires that the
USB-Blaster driver software be set up.
Power Up the
Development
Board
To power up the development board, perform the following steps:
1. Ensure that the red on/off switch (SW1) - on the back-side of the
development board is in the OFF position (up).
2. Connect the USB-Blaster cable from the host computer to the
USB-Blaster port on the development board.
3. Connect the 12-V DC adapter to the development board and to a
power source.
c Only use the supplied 12-V power supply. Power regulation
circuitry on the board could be damaged by supplies greater
than 12 V.
4. Press the Power Switch (SW1).
5. A Welcome screen appears as shown in Figure 2–1.
Vista de pagina 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 79 80

Comentarios a estos manuales

Sin comentarios