
Chapter 3: Board Setup and Defaults 3–5
Factory Default Switch and Jumper Settings
June 2014 Altera Corporation Arria V SoC Development Kit
User Guide
4. Set the following jumper blocks to match Table 3–4 and Figure 3–1.
Table 3–4. Default Jumper Settings
Board
Reference
Board Label Description
Default
Position
J3 FMCB
■ SHORT: FMCB is not in the JTAG chain
■ OPEN: FMCB is in the JTAG chain
SHORT
J6 FMC
Variable voltage:
■ 9-10: 1.2 V
■ 7-8: 1.5 V
■ 5-6: 1.8 V
■ 3-4: 2.5 V
■ 1-2: not valid
3-4: 2.5 V
J7 LMK_OSC_SEL
■ SHORT: Select to use SMA
■ OPEN: Select to use on-board VCXO
OPEN
J19 JTAG HPS SEL
■ SHORT: Controls the HPS from On-Board USB
Blaster II JTAG master.
■ OPEN: Controls the HPS from MICTOR-based
JTAG master, such as DSTREAM or Lauterbach
programming cables. Also, sets SW4.1 to ON to
remove the On-Board USB Blaster II from
driving the HPS JTAG input port in this mode.
SHORT
J21 JTAG SEL
■ SHORT: The USB Blaster II is the source of the
JTAG chain.
■ OPEN: The Mictor is the source of the JTAG
chain.
SHORT
J28 JTAG MIC SEL
■ SHORT: JTAG TRST input to HPS driven from
the JTAG chain.
■ OPEN: JTAG TRST input to HPS driven from the
MICTOR.
OPEN
J37 CLKSEL0 Selects the HPS clock settings.
(
1
)
SHORT pins
2-3
J38 CLKSEL1 Selects the HPS clock settings.
(
1
)
SHORT pins
2-3
J39 BOOTSEL0 Selects the boot mode and source for the HPS.
(
1
)
SHORT pins
1-2
J40 BOOTSEL1 Selects the boot mode and source for the HPS.
(
1
)
SHORT pins
2-3
J41 BOOTSEL2 Selects the boot mode and source for the HPS.
(
1
)
SHORT pins
1-2
Comentarios a estos manuales