
2–30 Chapter 2: Board Components
General User Input/Output
Transceiver Signal Integrity Development Kit July 2012 Altera Corporation
Stratix V GX Edition Reference Manual
User-Defined DIP Switch
Board reference SW4 is a 8-pin DIP switch. The switches are user-defined, and are
provided for additional FPGA input control. There is no board-specific function for
these switches.
Table 2–25 lists the user-defined DIP switch schematic signal names and their
corresponding Stratix V GX pin numbers.
Table 2–26 lists the user-defined DIP switch component reference and the
manufacturing information.
User-Defined LEDs
The development board includes eight user-defined LEDs. Board references D18
through D25 are user LEDs which allow status and debugging signals to be driven to
the LEDs from the designs loaded into the Stratix V GX device. The LEDs illuminate
when a logic 0 is driven, and turns off when a logic 1 is driven. There is no
board-specific function for these LEDs.
Table 2–25. User-Defined DIP Switch Schematic Signal Names and Functions
Board Reference
(SW4)
Schematic
Signal Name
I/O Standard
Stratix V GX Device
Pin Number
Description
1
S5_UNLOCK
2.5-V
—
(Connected to USB MAX II pin B6)
User-defined DIP switch
connected to FPGA device.
When the switch is in the
OPEN or ON position, a logic
1 is selected. When the
switch is in the CLOSED or
OFF position, a logic 0 is
selected.
2
USER_DIP6
2.5-V H34
3
USER_DIP5
2.5-V F33
4
USER_DIP4
2.5-V G33
5
USER_DIP3
2.5-V H32
6
USER_DIP2
2.5-V D34
7
USER_DIP1
2.5-V E34
8
USER_DIP0
2.5-V D33
Table 2–26. User-Defined DIP Switch Component Reference and Manufacturing Information
Board Reference Description Manufacturer
Manufacturer
Part Number
Manufacturer Website
SW4 Eight-Position DIP switch Grayhill 76SB08ST www.grayhill.com
Comentarios a estos manuales