
Switch Configuration
3 ON
4 OFF
5 ON
6 ON
The figure below illustrates the physical configuration of the SW switches on the Cyclone V SoC
Development Kit:
Setting Up Terminal Connection in Linux
To set up the terminal connection for the Cyclone V SoC Development Kit in Linux, specify the USB
virtual COM port settings.
1. Connect the board to your development machine via the micro-USB port that is closest to the power
supply connector on the board.
2. Connect the board to the power supply and power it up.
3.
Run the command dmesg | tail to determine which device the Future Technology Devices
International (FTDI) driver assigns for the connection (e.g. /dev/ttyUSB0).
4. Setup the minicom as follows:
a.
Ensure that minicom is installed on your system. If not, invoke the yum install minicom
command.
b.
Run minicom -s as root to enter the minicom setup mode.
c. Select Serial port setup and then press Enter.
d.
Press A to change Serial Device to /dev/ttyUSB0 and then press Enter.
e. Press E to change the port settings. Press E again to select 115200 for Speed, and then press Q to set
Data/Parity/Stopbits to 8-N-1 configuration.
3-8
Setting Up Terminal Connection in Linux
OCL006-15.0.0
2015.05.04
Altera Corporation
Setting Up the Altera SDK for OpenCL, SoC EDS, and the Cyclone V SoC Development Kit for Linux
Send Feedback
Comentarios a estos manuales