Altera JNEye Manual de usuario descargar pdf (Pagina 143)

relative permittivity of the substrate determine the characteristic impedance of the strip which is a

transmission line. A typical stripline structure is shown in the following figure with these parameters:

• Input parameters

• W—Signal trace width (in various units)

• L—Signal trace length (in various units)

• T—Signal trace thickness (in various units)

• H—Separation between ground planes (in various units)

• Er (Dk)—Relative dielectric constant. JNEye Channel Designer supports frequency dependent

dielectric constant mapping.

• TanD (Df)—Dielectric loss tangent. JNEye Channel Designer supports frequency dependent

dissipation factor mapping.

• Cond—Conductor conductivity (S/m)

• Rough—Surface roughness (in various units)

• Mur—Relative permeability (no unit)

• Freq—Frequency where the Z0 (Impedance) and E-Eff (electrical length) are reported (in various

units)

• Output parameters

• Z0—Impedance at specified frequency Freq (Ohm)

• E-Eff—Electrical length (in various units)

Figure 2-113: Stripline Channel Component Configuration

The channel component designer GUI can perform parameter unit conversion interactively. For example,

you can change the length unit from mil to mm and the GUI will automatically compute the length value

with the new unit.

UG-1146

2015.05.04

JNEye Channel Designer

2-137

Functional Description

Altera Corporation

Send Feedback

1 2 ... 138 139 140 141 142 143 144 145 146 147 148 ... 193 194

Sin comentarios

Altera JNEye Manual de usuario Pagina 143