Altera JNEye Manual de usuario Pagina 100

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 194
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 99
Figure 2-76: Rise/fall Time Histogram Plot
Waveform
For Hybrid mode or Full Waveform mode simulations, a waveform of each test point is plotted. The Data
Viewer, by default, displays the final 4096 bits of the waveform. Use the following settings to specify the
location of the waveform:
Plot—The Plot menu specifies the reference location of the simulated waveform. It has the following
choices:
Beginning—plots the waveform from the beginning of the simulation.
End—displays the last part of simulated waveform.
Custom—you specify the starting and ending bit locations.
Length—If the Plot selection is Beginning or End, the length of waveform (in bits) to be plotted is
specified.
From/to—If the Plot selection is Custom, these two entries specify the start and end points of
waveform (in bits) to be plotted.
2-94
JNEye Data Viewer Module
UG-1146
2015.05.04
Altera Corporation
Functional Description
Send Feedback
Vista de pagina 99
1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 193 194

Comentarios a estos manuales

Sin comentarios