Altera Internal Memory (RAM and ROM) IP Core Manual de usuario Pagina 5

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 57
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 4
Supported Memory Operation Modes
This table lists the supported memory operation mode and the related IP core for each operation mode.
Table 1-2: Supported Memory Operation Modes
Memory Operation Mode Related IP Core Description
Single-port RAM RAM: 1-PORT IP
Core
Single-port mode supports non-simultaneous read and write
operations from a single address.
Use the read enable port to control the RAM output ports
behavior during a write operation:
To show either the new data being written or the old data
at that address, activate the read enable during a write
operation.
To retain the previous values that are held during the
most recent active read enable, perform the write
operation with the read enable port deasserted.
Simple dual-port
RAM
RAM: 2-PORT IP
Core
You can simultaneously perform one read and one write
operations to different locations where the write operation
happens on port A and the read operation happens on port
B.
True dual-port RAM RAM: 2-PORT IP
Core
You can perform any combination of two port operations:
two reads, two writes, or,
one read and one write at two different clock frequencies.
Single-port ROM ROM: 1-PORT IP
Core
Only one address port is available for read operation.
You can use the memory blocks as a ROM.
Initialize the ROM contents of the memory blocks using
a .mif or .hex file.
The address lines of the ROM are registered.
The outputs can be registered or unregistered.
The ROM read operation is identical to the read
operation in the single-port RAM configuration.
Dual-port ROM ROM: 2-PORT IP
Core
The dual-port ROM has almost similar functional ports as
single-port ROM. The difference is dual-port ROM has an
additional address port for read operation.
You can use the memory blocks as a ROM.
Initialize the ROM contents of the memory blocks using
a .mif or .hex file.
The address lines of the ROM are registered.
The outputs can be registered or unregistered.
The ROM read operation is identical to the read
operation in the single-port RAM configuration.
1-2
Supported Memory Operation Modes
UG-01068
2014.12.17
Altera Corporation
About RAM: 1-PORT, RAM: 2-PORT, ROM: 1-PORT, and ROM: 2-PORT IP Cores
Send Feedback
Vista de pagina 4
1 2 3 4 5 6 7 8 9 10 ... 56 57

Comentarios a estos manuales

Sin comentarios