Altera Cyclone II DSP Development Board Manual de usuario Pagina 17

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 112
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 16
Altera Corporation Reference Manual 2–9
August 2006 Cyclone II DSP Development Board
Cyclone II DSP Development Board Components
Featured Device
The DSP Development Kit, Cyclone II Edition features the EP2C70F672
FPGA (U12) in a 672-pin FineLine BGA
®
package. Table 2–2 lists the
“Power Switch (SW1)” on page 2–57features of this device.
You can configure the FPGA in one of two ways:
Use Quartus II to program a SRAM Object file (SOF) file directly into
the FPGA via the JTAG connector.
f For details about configuring the EP2C70 FPGA, see the Getting Started
chapter in the DSP Development Kit, Cyclone II Edition Getting Started User
Guide.
Use Quartus II to load a design into the EPCS64 device via the ASI
connector and then cycle power to load the design from the EPCS64
device into the FPGA.
There are two EPCS64 devices, J29 determines which EPCS64 device
loads the FPGA. Refer to “EPCS64 Flash Memory Devices (U17,
U36)” on page 2–38 for more information.
User Interfaces
This section describes the user interfaces, which consist of LEDs,
switches, push-buttons, seven-segment display, line in, line out, audio
and headphone jacks, VGA, D/A converter, and A/D converter.
Table 2–2. Cyclone II EP2C70F672 Features
Feature Value
Embedded 18x18 multipliers 150
Logic Elements (LEs) 68,416
M4K RAM blocks (4 Kbits + 512 parity bits) 250
Maximum differential channels 262
PLLs 4 PLLs
Total RAM bits 1,152,000
User I/O pins 422
Vista de pagina 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 111 112

Comentarios a estos manuales

Sin comentarios