
6–12 Chapter 6: Board Test System
Using the Board Test System
Arria V GX Starter Kit November 2014 Altera Corporation
User Guide
The XCVR1 Tab
The XCVR1 tab allows you to perform loopback tests on the HSMC and SDI ports.
Figure 6–7 shows the XCVR1 tab.
1 You must have the loopback HSMC installed on the HSMC connector Port A and the
SDI loopback cable for all tests to function in external loopback mode. Otherwise, set
the PMA setting tab to test internal loopback mode (serial loopback = 1).
The following sections describe the controls on the XCVR1 tab.
Channel
The Channel control allows you to specify which interface to test. The following port
tests are available:
■ HSMA x4 XCVR [3:0]
■ HSMA x8 LVDS [7:0]
■ HSMA x3 CMOS
Figure 6–7. The XCVR1 Tab
Comentarios a estos manuales