Altera Arria V GT FPGA Manual de usuario Pagina 34

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 58
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 33
6–12 Chapter 6: Board Test System
Using the Board Test System
Arria V GT FPGA Development Kit November 2012 Altera Corporation
User Guide
The SFP/SMA/C2C Tab
The SFP/SMA/C2C tab (Figure 6–6) allows you to run test designs using the
respective transceiver interfaces on FPGA 1.
1 To run the SFP+ designs using this GUI, use the USER1_DIPSW to enable or disable
SFP lasers. To turn the SFP_A laser on, ensure that USER1_DIPSW[4] is in the OFF
position (toward the HSMC connector). To turn on the SFP_B laser, ensure that
USER1_DIPSW[5] is in the OFF position.
The following sections describe the controls on the SFP/SMA/C2C tab.
Status
The Status control displays the following status information during the loopback test:
PLL lock—Shows the PLL locked or unlocked state.
Channel lock—Shows the channel locked or unlocked state. When locked, all
lanes are word aligned and channel bonded.
Figure 6–6. The SFP/SMA/C2C Tab
Vista de pagina 33
1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 57 58

Comentarios a estos manuales

Sin comentarios