Altera Cyclone III FPGA Guía de usuario descargar pdf (Pagina 11)

September 2010 Altera Corporation Cyclone III FPGA Development Kit User Guide

3. Software Installation

Introduction

This section describes the following procedures:

■ “Installing the Cyclone III Development Kit”

■ “Installing the Quartus II Web Edition Software” on page 3–2

■ “Installing the USB-Blaster Driver” on page 3–3

1 Before starting the installation, verify that you have complied with the conditions

described in “Software Requirements” on page 2–2.

Installing the Cyclone III Development Kit

The license-free Cyclone III Development Kit installer includes all the documentation

and design examples for the kit.

To install the Cyclone III Development Kit, follow these steps:

1. Download the Cyclone III Development Kit installer from the Cyclone III FPGA

Development Kit page of the Altera website. Alternatively, you can request a

development kit DVD from the Development Kits, Daughter Cards &

Programming Hardware page of the Altera website.

2. Follow the on-screen instructions to complete the installation process.

When the installation is complete, the Cyclone III Development Kit installation

program creates the directory structure shown in Figure 3–1, where <path> is the

Cyclone III Development Kit installation directory.

Figure 3–1. Cyclone III Development Kit Installed Directory Structure

cycloneIII_3c120_dev

documents

examples

board_design_files

The default Windows installation directory is C:\altera\

<version#>

\kits.

factory_recovery

demos

<path>

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 47 48

Sin comentarios

Altera Cyclone III FPGA Guía de usuario Pagina 11