
Figure 9: ModelSim-Altera Software Simulation Waveforms
ALTUFM_PARALLEL Ports
Input Ports
Table 22: ALTUFM_PARALLEL Input Ports
CommentsDescriptionRequiredPort Name
Input port [WIDTH_
ADDRESS-1..0] wide.
The add port is used
with the parallel
interface protocol only.
(1)
Address bus.Yesaddr[]
Input port [WIDTH_
DATA-1..0] wide. (1)
Data bus input.Yesdi[]
When the ACCESS_
MODE parameter is set
to READ_ONLY, the
nerase port cannot be
used. (1)
Erase input port.Nonerase
(1)Read input port.Yesnread
(1)Write input port.Nonwrite
Note to Table 3–5:
1. This port is used with the parallel interface protocol only.
Altera Corporation
Altera User Flash Memory (ALTUFM) IP Core User Guide
Send Feedback
29
ALTUFM_PARALLEL Ports
UG-040105
2014.08.18
Comentarios a estos manuales