Altera MAX V CPLD Manual de usuario descargar pdf (Pagina 13)

January 2011 Altera Corporation MAX V CPLD Development Kit User Guide

4. Development Board Setup

The instructions in this chapter explain how to set up the MAX V CPLD development

board.

Setting Up the Board

To prepare and apply power to the board, follow these steps:

1. Ensure that the shunt jumper for J8 (connecting pins 9 and 10) is set to 3.3 V

(default setting).

2. To power up the board, plug in the USB cable to the host PC, and plug the other

end of USB cable into the board USB type B connector (J4). No other power supply

is needed.

When the board is powered up, the blue LED power indicator will illuminate.

1 It is also possible to power up the board through the BATT+ and BATT- connectors

using three 1.5-V batteries in series. However, once you plug in a USB cable, the board

disconnects the battery supply and obtains power from the USB cable.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 29 30

Sin comentarios

Altera MAX V CPLD Manual de usuario Pagina 13