Altera DSP Development Kit, Stratix V Edition Manual de usuario Pagina 20

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 58
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 19
4–4 Chapter 4: Development Board Setup
Factory Default Switch Settings
DSP Development Kit, Stratix V Edition July 2013 Altera Corporation
User Guide
2. Set the DIP switch bank (SW3) to match Table 4–2 and Figure 4–2.
f For details on the JTAG chain, refer to the DSP Development Kit, Stratix V
Edition Reference Manual. For USB-Blaster II configuration details, refer to the
On-Board USB-Blaster II page.
3. Set DIP switch bank (SW4) to match Table 43 and Figure 4–2.
Table 4–2. SW3 JTAG DIP Switch Settings
(1)
Switc
h
Board
Label
Function
Default
Position
1 MAX_JTAG_EN
Switch 1 has the following options:
When on (0), removes the MAX V system controller in
the JTAG chain.
When off (1), includes the MAX V system controller
from the JTAG chain.
Off
2 HSMA_JTAG_EN
Switch 2 has the following options:
When on (0), removes the HSMC Port A in the JTAG
chain.
When off (1), includes the HSMC Port A from the JTAG
chain.
On
3 HSMB_JTAG_EN
Switch 3 has the following options:
When on (0), removes the HSMC Port B in the JTAG
chain.
When off (1), includes the HSMC Port B from the JTAG
chain.
On
4 PCIE_JTAG_EN
Switch 4 has the following options:
When on (0), removes the PCI Express Edge connector
from the JTAG chain.
When off (1), includes the PCI Express Edge connector
in the JTAG chain.
On
Note to Table 42:
(1) If you plug in an external USB-Blaster cable to the JTAG header (J10), the On Board USB-Blaster II is disabled. The
JTAG chain is normally mastered by the on-board USB-Blaster II.
Table 4–3. SW4 MSEL DIP Switch Settings
(1)
Switch
Board
Label
Function
Default
Position
1 MSEL0 Configuration Setting 0 On (0)
2 MSEL1 Configuration Setting 1 On (0)
3 MSEL2 Configuration Setting 2 On (0)
4 MSEL3 Configuration Setting 3 Off (1)
5 MSEL4 Configuration Setting 4 On (0)
6 On (0)
Note to: Table 4–3
(1) Set MSEL[4:0] to valid configuration schemes as listed in the Stratix V Device
Handbook.
Vista de pagina 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 57 58

Comentarios a estos manuales

Sin comentarios