Altera DisplayPort MegaCore Function Manual de usuario Pagina 16

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 195
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 15
Related Information
DisplayPort IP Core Simulation Example on page 7-1
The Altera DisplayPort simulation example allows you to evaluate the functionality of the DisplayPort IP
Core and provides a starting point for you to create your own simulation. This example targets the
ModelSim SE simulator.
Simulating with the ModelSim Simulator
To simulate using the Mentor Graphics ModelSim simulator, perform the following steps:
1. Start the ModelSim simulator.
2. In ModelSim, change directory to the project simulation directory <variation>_sim/mentor.
3. Type the following commands to set up the required libraries and compile the generated simulation
model:
do msim_setup.tcl
ld
run -all
Compiling the Full Design and Programming the FPGA
You can use the Start Compilation command on the Processing menu in the Quartus II software to
compile your design. After successfully compiling your design, program the targeted Altera device with
the Programmer and verify the design in hardware.
Related Information
Quartus II Incremental Compilation for Hierarchical and Team-Based Design
Provides more information about compiling the design.
Quartus II Programmer
Provides more information about programming the device.
UG-01131
2015.05.04
Simulating with the ModelSim Simulator
3-3
Getting Started
Altera Corporation
Send Feedback
Vista de pagina 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 194 195

Comentarios a estos manuales

Sin comentarios