Altera ByteBlasterMV Manual de usuario Pagina 16

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 26
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 15
1–8 Altera Corporation
Installation
cd byteblaster r
3. Run the configure install script by typing the following command at the
command prompt:
./configure r
4. Compile the Altera ByteBlaster kernel driver by typing the following
command at the command prompt:
make r
5. Become root and compile the Altera ByteBlaster kernel driver module and
device nodes by typing the following command at the command prompt:
make install r
Installing the ByteBlasterMV Download Cable on a Linux
Workstation
To install and set up the ByteBlasterMV download cable on a Linux workstation
for device configuration or programming, follow these steps:
1. Attach the ByteBlasterMV download cable to a parallel port on your Linux
workstation and insert the 10-pin female plug into the prototype system
containing the target device, as shown in Figure 1–2.
1 The board must supply power to the ByteBlasterMV download
cable.
Vista de pagina 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 25 26

Comentarios a estos manuales

Sin comentarios