Altera Active Serial Memory Interface Manual de usuario Pagina 35

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 36
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 34
Date Version Changes
May 2013 4.1
Replaced the term dummy bytes with dummy cycles.
Removed the Use ‘die_erase’ port parameter in Table 2–1 on page 2–2.
This parameter is only available for selected customers.
Updated the Use ‘read_address’ port parameter in Table 2–1 on
page 2–2 to clarify that the width of the addr and read_address signals
is 24 bit for other devices.
Updated the caution statement in “About This Megafunction” on
page 1–1.
December 2012 4.0
Updated “Device Family Support” on page 1–3.
Added “Enable 4-byte Addressing Operation for an EPCQ256 Device”
on page 3–16, “EPCQ Devices Extended SPI Dual and Quad I/O
Instruction” on page 3–9, and “EPCQ Devices Read Dummy Clock
Instruction” on page 3–9.
Updated Figure 2–1 on page 2–1 to include new ports.
Updated the following sections to include EPCQ information:
“Read Memory Capacity ID from the EPCS/EPCQ Device” on page 3–
2.
“Fast Read Data from the EPCS/EPCQ Device” on page 3–7
“Read Data from the EPCS/EPCQ Device” on page 3–5
“Write Data to the EPCS/EPCQ Device” on page 3–10
“Erase Memory in a Specified Sector on the EPCS/EPCQ Device” on
page 3–14
“Erase Memory in Bulk on the EPCS/EPCQ Device” on page 3–15
“Protect a Sector on the EPCS/EPCQ Device” on page 3–4
“Read Status Register of the EPCS/EPCQ Device” on page 3–13
Updated Table 2–1 on page 2–3 to include new parameters.
Updated Table 2–2 on page 2–10 to include en4b_addr and asmi_
dataout ports information.
Updated Table 2–3 on page 2–13 to include asmi_dclk, asmi_scein,
asmi_sdoin and asmi_dataoe ports information.
Change document to new user guide template.
September 2009
3.0
Removed “Device Family Support”
Added new information in “Introduction” on page 1
Added “Parameter Settings” on page 17
Added link to Serial Configuration Devices (EPCS1, EPCS4, EPCS16,
EPCS64, and EPCS128) Datasheet
Updated to include information about read_rdid signal
Updated Figure 2 on page 3 to include Arria II GX and Stratix IV
Added Figure 1 on page 2
Removed “How to Contact Altera” and “Typographic Conventions”
sections.
UG-ALT1005
2014.12.15
Document Revision History
35
Altera ASMI Parallel IP Core User Guide
Altera Corporation
Send Feedback
Vista de pagina 34
1 2 ... 30 31 32 33 34 35 36

Comentarios a estos manuales

Sin comentarios