
4–4 Chapter 4: Development Board Setup
Factory Default Switch Settings
Stratix IV GT 100G Development Kit User Guide October 2010 Altera Corporation
3. Set the board jumpers to match Table 4–2, as shown in Figure 4–1.
f For more information about the FPGA board settings, refer to the Stratix IV GT 100G
Development Board Reference Manual.
Table 4–2. Jumper Settings
Board
Reference
Name
Default
Shunt Position
J40 USB DISABLE Not Installed
J41 JTAG_EN Installed
J42 VCCA_GXB DISABLE Not Installed
J55 FAN BYPASS ON Not Installed
Comentarios a estos manuales